Each mask is powered by a fan module exclusively customised for Philips Fresh Air Mask . This provides an air flow rate of up to 41 L/min.
The motor and air fluid dynamic design reduces the exhalation resistance and improves breathing comfort.
*Tested in accordance with conditions set by Philips.
Choose between a sealed filter or the N95 level protection filter for added protection.
*At the time of first use. With reference to the test conditions of the United States NIOSH and the Philips corporate standard, they are tested and certified by a third-party laboratory.Consumer should follow the instruction of use for such masks.
The “Golden Anchor Point” defined by the Philips laboratory through scientific force analysis effectively disperses the pressure of the mask on the bridge of the nose, cheeks and ears.
based on 23,000 Chinese facedata.
|
|
| 0-50 | 122 |
| 51-100 | 57 |
| 101-150 | 37 |
| 151-200 | 28 |
| 201-300 | 17 |
| 301-500 | 8 |
2 It is a recommendation of single total length of usage, based on data from the Philips laboratory. The actual time of replacement may be adjusted according to personal usage habits and actual environmental condition.
*Only applies to filter (FY0086).
It is recommended to charged the fan module until the white light is on steadily before first time use. A full charge takes about 3 hours.
After long-term use it is normal that the battery endurance decreases over time. Abnormal use such as extremely hot or cold condition will accelerate the battery attenuation. The mask does not work in extremely cold temperatures, it is best used in a environment around 10-35 ℃.
If the charging indicator flashes three times and turns off when the USB cable is connected, it is because the ambient temperature may be too high or too low. In order to protect the battery performance, it is recommended to charge in the range of 10 to 35 ℃. If the USB cable is connected, however the indicator light does not turn on, it could be due to the automatic protection mode. In such cases, it could be due to insufficient charging voltage or other special circumstances. If you experience this, please contact the Philips Consumer Care Service Centre.
Before you clean the product, make sure that the fan module is turned off and that no power is connected. Maintenance of module: wipe the surface with soft wet cloth or wet paper towel. Do not wash with water. Maintenance of filter: when the filter is damaged or dirty, please replace the filter. It is recommended to adjust the time of use according to PM2.5 indicates Maintenance of shell: please make sure the cover is separated from the fan module and filter. Wipe the surface with a soft, damp cloth, or soak in a neutral detergent, then lightly brush the surface with a soft brush (e.g., toothbrush) and rinse dry. Please refer to the user manual for a detailed illustration.
The filter is N95 level filtration performance. *With reference to the test conditions of the United States NIOSH and the Philips corporate standard, they are tested and certified by a third-party laboratory.Consumer should follow the instruction of use for such masks. 1. *Only applicable to filter (FY0086)
It is not recommended to be used during heavy rain or thunderstorms as it may affect the performance and lifespan of the mask.
No. The fan does not work during charging.
The mask can help to release the moisture or heat generated in the mask, reducing the possibility of foggy glasses when worn correctly. When wearing, please pay attention that the foam within the filter piece should be positioned firmly along the nose; put on the mask and adjust the nose clip to fit the bridge of the nose. Finally, adjust the length of the ear straps and check that the mask is placed firmly against the face.
FY0086/00 and FY0087/00 are compatible filters for the Philips Fresh Air Mask (ACM066). You can choose between a non-sealed filter (FY0086) or Sealed filter (FY0087).
The Fresh Air Mask has a international warranty of 1 year.