Using your Power Flosser

With the base station turned on:

1. Position the nozzle tip just above the gum line at a 90° angle. Press gently so that the nozzle tip is in contact with the gum line and the teeth.

2. Slide the pause switch on the handle to the 'on' position to start the water flow.

3. Starting from your back teeth in your upper or lower jaw, slide the nozzle tip along the gum line and pause briefly between each tooth. Continue to clean both inside and outside of your teeth in one arch of your mouth for 30 seconds.

4. Repeat in the other arch of your mouth for another 30 seconds until all spaces around and between your teeth have been cleaned for a total of at least one minute.

To prevent the nozzle from ejecting during use, ensure that you do not unintentionally push the nozzle eject button (13) while holding the handle.

1. When you are finished, turn off the product.
2. Remove and empty the reservoir.
3. Remove the nozzle from the handle by pushing the eject button on the back of the handle.
4. Rinse the nozzle under the tap.
5. Insert the nozzle back into the handle.
6. Dry any excess water off the tether and handle.