The Philips Nose Trimmer is a multi-functional device, which comfortably trims your nose, ear, and eyebrow hair. Your nose trimmer may not seem to work if you do not use the device properly. Other reasons that the product is not working might be that the battery is empty, or a cutting element is blocked. Watch the video below to see how to use the trimmer and for more in-depth detailed troubleshooting instructions, see the sections below.
Nose Trimmer cutting performance
Nose trimmers are built with a protective guard, such as the models with a cutting element on each side, ensuring the blades will not be in direct contact with the skin. The protection guard leaves short stubs of hair. It gives you a clean look without the risk of cuts, ingrown hairs, or hair pulling.
Insert the trimmer into your nose. Rotate the trimming head to catch the hairs growing in different directions. Do not insert the trimming head too far into your nostrils. For heads with a rotary tip, insert it about 5 mm. For trimming heads with a linear tip, insert it approximately 12 mm. While rotating, you may hold the flat side of the trimmer against the skin to reduce any tickling effect.
Always attach the eyebrow comb to the trimming head when trimming your eyebrows. The comb allows you to cut the hair to the desired hair length.
Checking battery capacity
Your Philips Nose Trimmer could stop working once the battery has run out. To confirm this, perform the following actions:
Switch off your nose trimmer.
Detach the trimming head and switch on the trimmer.
Is the motor running and pin rotating, then both the battery and handle are okay. If not, the battery of the trimmer has run out.
Reattach the head to the trimmer and recharge the nose trimmer.
Rechargeable products: While charging your trimmer make sure you use the original charger that comes with your device. For further charging instructions, please refer to the user manual.
For nose trimmers with disposable batteries, please see further instructions below.
Trimmers with disposable batteries
If you own a nose trimmer which runs on disposable AA batteries, it is possible that it is time to replace them. To solve this issue simply replace the battery with a new one. When replacing the battery, make sure that the + and - poles of the battery point in the right direction. This is indicated on the battery compartment.
Cutting unit is blocked
If you have confirmed that your Philips Nose Trimmer has a full battery and it is still not working, then it may not be working because it is dirty and the cutting unit is blocked. We advise that you clean your nose trimmer after each use for optimal performance.
Follow our cleaning advice below:
Rinse the trimming head of the nose trimmer with lukewarm water. Switch on your nose trimmer after 15 seconds and switch off the appliance again after 5 seconds. Retry a few times.
If rinsing the trimming head under the tap is not sufficient, immerse the trimming head in a glass of warm water for a few minutes. Do not put the handle of the trimmer in the water, as this can damage its internal machinery. Repeat step 1 again.
If this does not help, detach the nose trimmer attachment and soak this part separately in water for 8 hours. Reattach and repeat step 1 again.
If the trimmer is operable again: carefully shake off excess water and let the trimmer air dry.
For best results, clean your nose trimmer after each use and lubricate the trimming head with a drop of sewing machine oil every six months.
After using the nose trimmer, it is normal to observe remaining hairs. The hairs will be cut to a short length so the remaining hairs will continue to provide safe and comfortable protection (as a defense system to keep particles out of the body). When using the trimmer, make sure that the side with the cutting element touches the hair by rotating the trimming head around.
If you have tried the advice above but your nose trimmer still does not work, then please contact us for further assistance.