Avent DECT baby monitor



Why does the LINK light on the parent unit flash red? Only for SCD499: Why is the message (Not LinKed) shown on the display?

  • The baby unit and the parent unit are out of range of each other. Move the parent unit closer to the baby unit.
  • The batteries of the baby unit are running low. Replace the batteries or connect the baby unit to the mains. See the user manual for more information.
  • The link was lost and the PU starts searching for a link with the BU The baby unit is switched off

The information on this page applies to the following models: SCD496/00 , SCD497/00 , SCD498/00 , SCD499/00 . more less

Not what you are looking for?

Did we answer your question?

If not, contact us.